Present an error message before output when a Warp Stabilizer watermark is on a clip
If you have altered a clip with the Warp Stabilier and your clip now has a Warp Stabilizer "Frame not analyzed" watermark warning, Premiere Pro should warn the editor this is there before and output. This would avoid this watermarked shot being rendered into an export before the editor could fix it.
In fact any undesirable thing like a watermark banner should be presented to the editor before an export. In the end I would rather have a shot export WITHOUT the Warp Stablizer at all than to have it export with a watermark.
Scott Simmons
shared this idea
9 comments
-
Benjamin Fleming
commented
Agreed, but you do have the option of turning off the warning banner altogether when applying the effect. Not a fix but does prevent exporting with the warning.
-
Rick van Modem
commented
@Mat Thomas, you have to show me how this magic works for you.. Cause I've just rendered the same video for the 6th time, only to find ANOTHER clip that needs to re-analyze...
-
Mat Thomas
commented
I'm pretty sure this is already present in Premiere Pro. When i go to export and a warp stabilizer has not been completed/started etc, a pop up appears with the relevant timecode of that particular clip.
-
micah haun
commented
Same with Morph cut and anything else that has a processing phase.
-
Lia Lenart
commented
AGREED!
-
David Franklin
commented
Agree. An output without the effect would be preferable to an output with watermark that says the effect hasn't analyzed the frame. But really, just fix this so that there's no possibility of baking an error watermark into an export. Especially for longer shows this is an essential change.
-
Dina Guttmann
commented
This would save HOURS!
-
Michael Wells
commented
Very much needed!
-
Jason Thibodeaux
commented
I don't comment much (I possibly could have zero comments) but this right here is important to note and fix please.