Bug: In source monitor, in/out points are drawn in the wrong place
This is sporadic yet recurring over days and different clips.
- Set in & out points for clip X. Everything looks as it should.
- Go edit, load some other clips.
- Reload clip X in the source monitor.
- Go to in.
- The CTL will jump to a spot different than the beginning of the gray in-out range display. For example. in point is 01:57:11:22 but the range is drawn from 01:57:21:13. The out point is off, too.
Only solution is to make new in/out points.
This may or may not only happen with clips interpreted to a different frame rate.